IEI Integration PCIE-Q57A - Manual (Page 57)

PCIE-Q57A PICMG 1.3 CPU Card
Page 45
Step 2: Insert the cable connectors. Insert one connector into each serial port box
headers. See Figure 4-9. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 4-9: Dual RS-232 Cable Installation
Step 3: Secure the bracket. The dual RS-232 connector has two D-sub 9 male
connectors secured on a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the chassis. Step 0:
4.7.2 SATA Drive Connection
The PCIE-Q57A is shipped with two SATA drive cables and one SATA drive power cable.
To connect the SATA drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-10.