Extron Electronics XTRA Full Rack Series User Guide User Manual

Page 24

Audio output

Number/signal type

XPA 2002 ................................ 2 channels, 4 or 8 ohms; or 1 bridged mono, 8 ohms
XPA 2002-70V ......................... 2 channels, 70 V
XPA 2002-100V ....................... 2 channels, 100 V
XPA 2003C-70V ....................... 2 channels, 4 or 8 ohms

1 channel, 70 V

XPA 2003C-100V ..................... 2 channels, 4 or 8 ohms

1 channel, 100 V

XPA 2004 ................................ 4 channels, 4 or 8 ohms; or 2 bridged mono, 8 ohms

Connectors

XPA 2002 ................................ (1) 5 mm screw lock captive screw connector, 4 pole
XPA 2002-70V, XPA 2002-100V (2) 5 mm screw lock captive screw connectors, 2 pole
XPA 2003C-70V, XPA 2003C-100V

(1) 5 mm screw lock captive screw connector, 4 pole
(1) 5 mm screw lock captive screw connector, 2 pole

XPA 2004 ................................ (2) 5 mm screw lock captive screw connectors, 4 pole

NOTE:

These connectors accept wires of 22 AWG to 12 AWG.

Load impedance

XPA 2002-70V ......................... 25 ohms minimum
XPA 2002-100V ....................... 50 ohms minimum
XPA 2003C-70V

Channel 1 or 2 ................... 4 ohms minimum
Channel 3 .......................... 25 ohms minimum

XPA 2003C-100V

Channel 1 or 2 ................... 4 ohms minimum
Channel 3 .......................... 50 ohms minimum

XPA 2002, XPA 2004 ............... 4 ohms (8 ohms if bridged) minimum

Amplifier type ................................ Class D
Output power

XPA 2002-70V ......................... 200 watts rms per channel, 70 V, 1 kHz, 0.1% THD
XPA 2002-100V ....................... 200 watts rms per channel, 100 V, 1 kHz, 0.1% THD
XPA 2003C-70V

Channel 1 or 2 (8 ohm) ...... 100 watts rms per channel, 8 ohms, 1 kHz, 0.1% THD
Channel 1 or 2 (4 ohm) ...... 200 watts rms per channel, 4 ohms, 1 kHz, 0.1% THD
Channel 3 (70 V output) .... 200 watts rms per channel, 70 V, 1 kHz, 0.1% THD

XPA 2003C-100V

Channel 1 or 2 (8 ohm) ...... 100 watts rms per channel, 8 ohms, 1 kHz, 0.1% THD
Channel 1 or 2 (4 ohm) ...... 200 watts rms per channel, 4 ohms, 1 kHz, 0.1% THD
Channel 3 (100 V output) .. 200 watts rms per channel, 100 V, 1 kHz, 0.1% THD

XPA 2002, XPA 2004 ............... 100 watts rms per channel, 8 ohms, 1 kHz, 0.05% THD

200 watts rms per channel, 4 ohms, 1 kHz, 0.05% THD
400 watts rms (bridged mono), 8 ohms, 1 kHz, 0.05% THD

Frequency response ........................ 20 Hz to 20 kHz, ±1 dB
THD + Noise

XPA 2002-70V, XPA 2002-100V 0.1%, 1 kHz, 3 dB below clipping
XPA 2003C-70V, XPA 2003C-100V

Channels 1 and 2: 0.1%, 20 Hz-20 kHz, 8 ohms, 3 dB below
clipping
Channel 3: 0.1%, 1 kHz, 3 dB below clipping

XPA 2002, XPA 2004 ............... 0.1%, 20 Hz to 20 kHz, 8 ohms, 3 dB below clipping

XTRA Full Rack Power Amplifier Series • Reference Information