Extron Electronics SW HDMI Series User Guide User Manual
Page 29
SW HDMI Series • Remote Communication and Control
23
Command
ASCII Command
(Host to Switcher)
Response
(Unit to Switcher) Additional Description
EDID Minder (continued)
Save display EDID to user
location
E
S *
X$
EDID
}
EDID S
X$
]
Store the EDID of the connected display
as user-assigned EDID file
X$
.
X$
= 47 through 50.
View EDID native resolution
E
N * EDID
}
X^
]
Show native resolution and refresh rate
X^
from current EDID selection.
Example
E
N * EDID
}
1600x1200 @ 60 Hz
]
Front Panel Lockout
Enable or disable lock mode
X*
X
Exe
X*
]
Select front panel lock mode
X*
. For
X*
:
1 = front panel locked
0 = front panel unlocked (default)
View lockout status
X
X*]
Show executive mode On or Off status.
Front Panel IR Receiver Enable and Disable
Enable and disable IR receiver
X1!
* 65#
IRDisable
X1!
]
Disable the IR remote receiver on the
front panel from receiving signals from
the IR remote control.
View IR status
65#
X1!
]
View IR receiver status
X1!
. For
X1!
:
0 = IR Disable feature is off (IR enabled).
1 = IR Disable feature is on (IR disabled).
Information Requests
Request information
I
V
X!
• F
X$
• Vmt
X@
• Amt
X@
]
Show the selected input, EDID selection,
video muting status, and audio muting
status.
X!
= input number: 1 through highest
number of inputs available.
X@
= video or audio mute status:
1 = muted; 0 = unmuted
X$
= Current EDID (1 through 50)
0 = Automatic (no EDID selected)
Example:
I
V4 • F2 • Vmt0 • Amt0
]
On an SW4 HDMI, input 4 is selected,
EDID 2 (1024x768 @ 60 Hz) is selected,
and neither the video nor the embedded
audio is muted.
Request part number
N
60-nnn-nn
]
Show the part number of the switcher
(see “
model part numbers).
Query firmware version
Q
X&
]
Show firmware build number
X&
,
expressed to the second decimal place.
Example:
Q
1.01
]
Query auto-input switching
status
72#
Asw
X1!
]
Show status of auto-input switching.
For
X1!
: 0 = disabled; 1 = enabled
Resetting
Reset
E
ZXXX
}
Zpx
]
Reset the switcher to its factory default
values.
Uploading Firmware
Upload firmware
E
Upload
}
...go
Upl
]
Upload a new firmware version from the
computer. Upl appears after the upload
is complete.