White’s Electronics Spectrum XLT - Manual (Page 38)

38
Chapter 5 XLT ® Pro Options
15. BLOCK Edit
Speeds major EDIT changes by dragging ACCEPT
or REJECT with ARROW controls.
Allows major EDIT changes to be completed
quickly. EDIT is for individual V.D.I. number
changes and/or viewing of the current settings.
BLOCK EDIT is for changing multiple V.D.I.
numbers, or ranges.
CAUTION: You cannot view settings without
changing ACCEPT or REJECT status in BLOCK
EDIT.
Select BLOCK EDIT with the ARROW controls
and press ENTER. The ENTER control can be
used to select either ACCEPT or REJECT. The
ARROW controls can then be used to drag that
ACCEPT or REJECT status as far as desired
through the V.D.I. number range. When a V.D.I.
number or range of numbers appear that you want
set differently, stop dragging with the ARROWs,
press ENTER to change the ACCEPT / REJECT
status, and then drag that new status as far as you
desire. ENTER changes ACCEPT / REJECT;
ARROWS drag that ACCEPT / REJECT status;
ENTER again changes ACCEPT / REJECT;
ARROWS drag that new ACCEPT / REJECT
status, etc.
BLOCK EDIT not only saves time if large sections
of the V.D.I. target numbers are to be changed, it
also allows peace of mind in the certainty of how
all the V.D.I. numbers are set. In the same amount
of time it takes to view all the V.D.I. number's
current status in regular EDIT, you can set them
the way you desire in BLOCK EDIT.
BLOCK EDIT
ACCEPT
REJECT
TO CHANGE PRESS ENTER
+72
(Discrimination section)
Tips - If more than a few
V.D.I. numbers are to be
changed, use BLOCK
EDIT.