Asus Desktop Barebone Pundit P3-PH5 - Manual (Page 83)

ASUS Pundit P3-PH5 5-23
5.4.4 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an
item then press to display the sub-menu.
Advanced Chipset Settings
WARNING: Setting wrong values in below sections
may cause the system to malfunction.
NorthBridge Configuration
NorthBridge Configuration
Memory Remap Feature [Disabled]
Allows you to enable or disable the remapping of the overlapped PCI memory
above the total physical memory. Enable this option only when you install 64-
bit operating system. Configuration options: [Disabled] [Enabled]
Configure DRAM Timing by SPD [Enabled]
When this item is enabled, the DRAM timing parameters are set according to
the DRAM SPD (Serial Presence Detect). When disabled, you can manually
set the DRAM timing parameters through the DRAM sub-items.
Configuration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to select the graphics controller as the primary boot device.
Configuration options: [IGD] [PCI/IGD] [PCI/PEG] [PEG/IGD] [PEG/PCI]
Internal Graphic Mode Select [Enabled, 8MB]
Allows you to select the amount of system memory used by the Internal
graphics device.
Configuration options: [Disabled] [Enabled,1MB] [Enabled, 8MB]
Configure North Bridge
feature.
North Bridge chipset Configuration
Memory Remap Feature [Disabled]
Configure DRAM Timing by SPD [Enabled]
Initiate Graphic Adapter [PEG/PCI]
Internal Graphic Mode Select [Enabled, 8MB]
Fixed Graphic Memory Size [128MB]
DVMT Graphic Memory Size [128MB]
PEG Port Configuration
PEG Force x1 [Disabled]
ENABLED: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLED: Do not allow
remapping of memory