Asus Desktop Barebone Pundit P3-PH5 - Manual (Page 54)

- Chapter 4: Motherboard info
2. Primary IDE connector (40-1 pin PRI_EIDE)
This connector is for an Ultra DMA 100/66 signal cable. The Ultra
DMA 100/66 signal cable has three connectors: a blue connector for the
primary IDE connector on the motherboard, a black connector for an Ultra
DMA 100/66 IDE slave device (optical drive/hard disk drive), and a gray
connector for an Ultra DMA 100/66 IDE master device (hard disk drive). If you
install an optical drive and an IDE HDD, you must configure the optical drive
as a slave device by setting its jumper accordingly. Refer to the optical drive
or HDD documentation for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
R
P5B-V
M
P5B-VM IDE Connector
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
PRI_EIDE
PIN1