Vestil PEL-A series - Manual

1
Vestil Manufacturing Company
2999 North Wayne St., Angola, IN 46703
Ph 260-665-7586 • Fax: 260-665-1339
E-mail: [email protected] • www.vestil.com
WARNINGS & SAFETY INSTRUCTIONS
Read owner's manual completely before operating unit!
• Never go under deck if there is load on unit.
• Never operate unit unless you are watching it.
• Stand clear from load when operating.
• Do not operate unit unless all cover plates are securely
in place.
• Do not continue to press the up-button if deck is not
raising.
• Never exceed the maximum loading capacity
model PEL-88A & PEL-88 .................................. 175 lbs.
model PEL-100A & PEL-100 .............................. 125 lbs.
model PEL-400-57 & PEL-400-72 ....................... 400 lbs.
• Load must be evenly distributed on deck to ensure
stability.
• Consult factory for uneven loading.
• Always operate unit on a level surface to ensure stability.
• Always apply wheel brakes when unit is not being
moved.
• Use caution in moving a loaded unit; avoid obstructions
and floor defects.
• Remove load & disconnect power before working on unit.
• Consult factory if adding or performing any modifications
to the original equipment.
• Use only maintenance parts supplied or approved by the
manufacturer.
• Make sure all operator safety labels are in place.
ALUMINUM QUICK LIFTS
MODEL PEL-88A & PEL-100A
STEEL QUICK LIFTS
MODEL PEL-88, PEL-100 & PEL-400
OWNER'S
MANUAL
Revised 06-04 21-126-104
A company dedicated to solving ergonomic and material
handling problems since 1955.
ALUMINUM & STEEL
QUICK LIFTS
Ergonomic Solutions
CONTENTS
Warning and Safety Instructions ............................ 1
Receiving Instructions ............................................ 1
Loading Instructions ............................................... 2
Operating Instructions ............................................ 2
Electrical Diagram .................................................. 3
Troubleshooting Guide ........................................... 4
Parts for PEL-88A & PEL-100A ............................. 5
Chain Tension Adjustment for PEL-88 .................... 7
Parts for PEL-88 & PEL-100 ................................8-9
Warning Labels for PEL-88 & PEL-100 ................ 10
Chain Tension Adjustment for PEL-400 ................ 11
Parts for PEL-400 ............................................12-13
Warning Labels for PEL-400 ................................. 14
Limited Warranty ................................................... 15
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior
to shipment. However, it is possible that the unit may incur
damage during transit. If you see damage when unloading
make a note of it on the SHIPPER RECEIVER.
Remove all packing and strapping material, inspect for
damage. IF DAMAGE IS EVIDENT, FILE A CLAIM WITH
THE CARRIER IMMEDIATELY! Also, check the unit size,
type of power unit, etc., to ensure the unit is correct for
the intended application.
PEL-88A
PEL-100A
PEL-88
PEL-100
PEL-400-57
PEL-400-72
E
S
P
A
N
O
L
E
N
G
L
I
S
H
F
R
A
N
Ç
A
I
S
Warning Labels for PEL-88A & PEL-100A..............6