Vestil JMD-1000 - Manual

02/25/05 34-126-120.doc
V ESTIL M FG . C O ./T&S E QPT . C O . 1 of 11
V ESTIL M ANUFACTURING C ORP .
2999 N. Wayne St., Angola, IN 46703
Ph: 260-665-7586 · Fax: 260-665-1339
E-mail:
[email protected] · www.vestil.com
M
ODEL
JMD-1000 M
ULTI
-P
URPOSE
T
OTE
D
UMPER
Serial number ____________
Warnings & Safety Instructions .....………………..… 2
Operation Instructions ……………………….….…… 3
Routine Maintenance & Safety Checks ……………… 4 Electrical & Hydraulic Diagrams & BOM ………..…. 5-9
Troubleshooting …………………………....….……… 10
Warranty …………………………………….….…..…. 11
I MPORTANT N OTES
Ensure that all employees understand and follow the following.
o
Read and understand the owner’s manual before using or servicing
the tote dumper.
o
The load must be removed and the carriage fully lowered before any
work is performed on the tote dumper.
o
Ensure that all safety and warning labels stay in place and are
legible.
o
Do not use the tote dumper if any damage or unusual noise is
observed.
o
Always watch the container carefully when the tote dumper is in
operation.
o The tote dumper is intended for use only on compacted, improved
surfaces.
o
Do not use brake fluid or jack oils in the hydraulic system. If oil is
needed, use an anti-wear hydraulic oil with a viscosity grade of
150 SUS at 100°F, (ISO 32 cSt @ 40°C), or Dexron transmission fluid.
o
Contact the manufacturer for any needed MSDS information.
♦ Do not perform any modifications to the tote dumper without the
manufacturer’s approval. Failure to receive authorization for
changes to the equipment could void the warranty.
♦ Maintenance and repairs are to be done only by personnel qualified
to perform the required work. Consideration will not be given for
warranty repair labor charges without prior written authorization by
the manufacturer.
WHEN ORDERING
REPLACEMENT PARTS :
We take pride in using quality
parts on the equipment we
manufacture. We are not
responsible for equipment
problems resulting from the use
of unapproved replacement
parts.
To order replacement or
spare parts for this equipment,
contact the factory.
In any communication with
the factory please be prepared
to provide the machine’s serial
number, which is indicated on
the machine dataplate.
R ECEIVING INSTRUCTIONS
Every unit is thoroughly
tested and inspected prior to
shipment. However, it is
possible that the unit could
incur damage during transit.
Inspect the unit closely when
it arrives. If you see evidence
of damage or rough handling to
either the packaging or to the
product when it is being
unloaded, immediately make a
note of it on the Bill Of Lading!
It is important that you
remove the product’s packaging
upon its arrival to ensure that
there is no concealed damage
or to enable a timely claim with
the carrier for freight damage.
Also verify that the product
and its specifications are as
ordered.
O
WNER
’
S
M
ANUAL