Label #218, Fig. 7: product label placement diagram – Vestil FMDL User Manual

Page 12

08/2010

rev. 11/16/2012

FMDL manual, operation instructions.doc

Page 12 of 12

2. Product labels: all labels should be readable and located as shown in FIG. 6. If a label(s) is unreadable or

missing, contact Vestil to order a replacement.

At least 1 time per month, inspect:

1. Fasteners (hardware):

Bolts, nuts, washers, pins, cotter pins;

Chain and snap hook.

2. Fork pockets: confirm that each pocket is structurally sound, uncorroded and free of rust. Do not use the lifter if

the fork pockets are structurally compromised, rusted or corroded.

3. Welds: confirm that all welds are intact.
4. Drum grippers, Eagle Beak® upper and/or lower jaw, fork pockets, and supporting frame: must be undamaged.

For example, no structural deformation, warps, or cracks.

5. Overall condition of drum lifter: the structure should be clean, square and rigid, and free of rust and corrosion.

Remove dirt and debris. Do not use the lifter if the supporting frame and/or one or both grippers are excessively
rusted or corroded.

FIG. 7: Product label placement diagram

Label #218:

Label #218