Voltage requirements, Placement and mounting, Hub location – Asante Technologies FH208B User Manual
Page 15: Self-adhering rubber feet, Desk stands, Voltage requirements -5 placement and mounting -5, Link/act 100mbps
Cabling and Voltage Requirements
Page 2-5
Voltage Requirements
Voltage requirements for all models:
❑
100 to 240Vac, 50/60Hz, 1.2A maximum
▲
Important! Check the AC power line voltage used in your
area.
Placement and Mounting
Hub Location
The location chosen for the Dual-speed FriendlyNet Hub should be less than
100 meters from servers, workstations, or switches.
▲
Caution! Category 5 cables are environment-sensitive.
Make sure that the cable route is not too close to electro-
magnetic noise sources such as power lines or fluorescent
lights.
Self-adhering Rubber Feet
To place the hub on a the desktop, apply the self-adhering rubber feet to the
bottom four corners as shown in Figure 2-8.
Figure 2-8 Self-adhering Rubber Feet
Desk Stands
Desk stands easily attach to a hub without screws, bolts or tools. See Figure 2-9.
To stack hubs using desk stands:
1
Attach two stands to each side of the first hub.
FriendlyNet
FH216
Link/Act
100Mbps
MDI – II
MDI – II
1
2 3
4
5
6
7
8
9
10
11
12
13
14
15
16
1 3 1 4 1 5 1 6
5
6
7
8
9
1 0
1 1
1 2
1
2
3
4
16-port Dual-speed Ethernet Hub
Auto
Power
Switch
Collision
10 100
or
or
1 0 / 1 0 0 M b p s P o r t s
1 0 / 1 0 0 M b p s P o r t s