Vestil DRUM-GRAB - Manual (Page 4)

rev. 11/12/2012 Drum-Grab, manual.doc
Use Instructions
Step 2: [NOTE: Make sure that the rubber spring is in
line with the pivoting arm.] Maintain constant contact
between the rims hooks and the rim of the drum while
pulling the lifting ring towards you to compress the
rubber spring. Compress the spring until the rim hook
of the pivoting arm engages the rim. Step 1: Grasp the Lifting Ring with one hand and lift the
pivoting arm (blue) upwards with the other hand. You
will only need to raise the pivoting arm slightly. Position
the Drum-Grab above the drum. Reach across the top
of the drum and engage the drum rim with the rim
hooks of the 2 fixed (non-pivoting) arms.
To release the Drum-Grab:
As noted in the Safety Guidelines, the drum must be entirely supported by the ground before it is
disengaged.
Pull the lifting ring towards the rim hook of the pivoting arm to compress the rubber spring. When the spring is
sufficiently compressed, separate the rim hook from the rim; then lift the pivoting arm and slowly allow the spring
to recoil. The fixed arms can now disengage the rim.
Copyright 2012 Vestil Manufacturing Corp. Page 4 of 6