Vanguard EZCT-2000 - Manual (Page 21)

REV 3 EZCT-2000 USER’S MANUAL
17
2. NO
Press the
[2]
key if you do not want to enter the CT nameplate values. Continue
to step g.
g. The following screen will be displayed:
Use the alpha-numeric keys on the keypad to enter a test note. The test note field is 20
characters long. One test note can be saved for each test.
When pressing a key, the corresponding number on the key will be displayed first.
Pressing the key again will display the first letter on the key. Pressing the key again will
display the second letter on the key. For example, to type the letter “A”, you must press
the
[2] key twice. To erase the character at the cursor position, press the [CLEAR] key.
Press the [PAPER ∧ Contrast] button to move to the next character. Press the
[PAPER ∨ Contrast]
key to move to the previous character. Press the
[ENTER]
key
when you are done typing the note.
h. The following screen will be displayed if the selected test included a resistance test:
Press the [1] key (YES). Selecting this option will print the current ratio error table as
part of the tabulated test results. Please see item 19 in Figure 6.
i. The following screen will be displayed:
NOTE
If you had selected a test current greater than 1 Amp in step e, the following
screen will be displayed:
Press any key to continue.
Type the burden value using the keypad and then press the [ENTER] key.
ENTER BURDEN VA:
(500.0 MAX)
0.0
SATURATION CUR WILL
BE REDUCED TO 1 AMP.
(PRESS ANY KEY...)
CALC ERR VS BURDEN?
1. YES
2. NO
ENTER TEST 1 NOTE:
↑/↓ TO POSITION
“ENTER” TO ACCEPT