Vanguard EZCT-10 - Manual (Page 30)

EZCT VERSION 5.x SOFTWARE MANUAL REV 1
28
5. You can change the tap order for the summary report display (last page of the test
record) by clicking on a tap and then clicking on the up or down arrow to the right of the
dialog box. The selected tap will be moved up or down on the list respectively. The
summary report will then display the information for each tap in this order as shown
below:
6. If you have a CT Tester connected to the PC, you can quickly repeat any of the tests
listed. Click on the “Repeat Test” check box next to the test that you would like to run.
The test options will become active as shown below:
NOTE
This option is available only if the CT Tester is connected to the PC. If a CT
Tester is not connected to the PC, the “Repeat Test” option will be grayed
out.
• You can change the nameplate ratio values by changing the high and low values.
• You can select which tests to run by checking or un-checking the corresponding
check box for each test (Ratio Test, Excitation Test).
• You can select the excitation voltage from the “Excitation Voltage” drop-down list.
• Any relevant test notes can be entered in the “Test Note” field.