Vanguard CT-7500 S2 User Manual
Page 29
REV 2 CT-7500 S2 USER’S MANUAL
24
3.1.12. Setting the Units of Measure
The CT-7500 S2 supports and displays both English and Metric calculations. You can switch
between the English and Metric systems using the steps below:
a. Start from the “START-UP” menu:
Press the
[3]
key (SETUP).
b. The following screen will be displayed:
Press the
[2]
key (MEASUREMENT UNITS).
c. The following screen will be displayed:
Press the
[1]
key (ENGLISH) or the
[2]
key (METRIC) to select the corresponding
measurement system. The measurement system will be set and you will be returned to
the “START-UP” menu.
NOTE
If the measurement system is changed, any relevant values in the working
memory will be automatically converted to the new system. Also, if retrieving
a test record from the Flash EEPROM, all data will be converted to the new
measurement system. There is no need to re-run a test.
SELECT UNITS:
1. ENGLISH
2. METRIC
3. ROTARY ENCODER
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. TIME BRKR 02/17/11
2. GET RSLT 13:08:25
3. SETUP
4. DIAGNOSTICS