Vanguard Herculito - Manual (Page 12)

Herculito Operating Procedures
11
6.1.3 Run Test Procedure
To run a test, turn the control knob until RUN TEST appears on the display, then press the
control knob to begin the procedures for running a test. The following menus prompt the user to
run a test.
Figure 6 Run Test Menu Prompts
The above menu shows the final resistance measurement and the test current at which the
resistance was measured. After the result is examined, press or turn the control knob for to
return to the “MAIN MENU” menu.
Figure 7..Main menu
BURNING IN: 02
120.1 MICRO-OHM
Remaining burn-in
time
MAIN MENU
MAIN MENU
“PRESS” TO START
“TURN” TO ABORT
WAIT FOR BEEP
THEN RELEASE
FINAL TEST RSLT:
120.1 MICRO-OHM