Teledyne LeCroy SDA II - Manual (Page 5)

Operator's Manual
Setting Up SDAII
Use the following steps to start your SDAII setup.
1. If you haven't done so already, touch Analysis → Serial Data on the menu bar.
2. On the Serial Data Analysis II dialog, place a checkmark in the Enable SDA box.
3. Touch the Setup Signal Inputs button to configure your signal input sources, crossing levels, and sig-
nal type.
Note: Touch the Quick View button to quickly set up and view your serial data.
4. If you are recovering clock data from the data signal (the default selection), make sure the clock
recovery input multiplexer switch is in the up position (clock recovery via the red path).
When the switch is in the up position, the Setup Ref. Clock button is disabled (grayed out).
5. Touch the Setup Clock Recovery button and define clock recovery settings, such as Bit Rate and PLL
settings.
OR
If you are using an explicit reference clock, click the clock recovery multiplexer switch button so that
the switch is in the down position.
6. The Setup Reference Clock Inputs button is then enabled. Click this button and set up your reference
clock inputs.
7. On the far right of the Serial Data Analysis II dialog, place a checkmark in the Enable Eye Meas. box
and click the Setup Eye Measurements button (showing its respective dialog) to define eye meas-
urement settings.
8. On the far right of the Serial Data Analysis II dialog, place a checkmark in the Enable Jitter Meas.
box and click the Setup Jitter Measurements button (showing its respective dialog) to define jitter
measurement settings. The Jitter Measure dialog opens displaying another flow diagram.
922968 Rev A 3