Teledyne LeCroy QPHY-MOST150 - Manual (Page 6)

6
920456 Rev B
USING QUALIPHY MOST150 OPHY
QualiPHY MOST150 oPhy guides the user, step-by-step, through each of the tests described in the
specification: MOST150 oPHY Automotive Physical Layer Sub-Specification Rev. 1.1, 05/2010. To do
this, the user must set up a test session.
Users choose the test configuration they wish to run. There are five pre-loaded test configurations. They
are:
• All Tests [demo]
• All Tests [differential and optical probe]
• All Tests [differential probe only]
• All Tests [direct connections]
• All Tests [optical probe only]
These pre-loaded configurations provide quick and easy ways to begin compliance testing. If the user
does not want to run any of these configurations, they can create their own custom configuration (see
the following section entitled Customizing QualiPHY for details).
The pre-loaded configurations are set up to run all of the compliance tests. If this is not what the user
wants, the variables can be modified (see the QPHY-MOST150o Variables section of this manual).
The variables are pre-loaded with the standard settings for compliance testing; however, the user may
choose to create their own configuration with the variables set as desired.