Teledyne LeCroy Line Code and Symbolic Decoders - Manual (Page 17)

Instruction Manual
922663 Rev A 15
Manchester/NRZ Table Columns
You may display these columns on a Manchester or NRZ result table:
Idx - Index number of table row.
Time - Location of event relative to trigger position.
Sync - Location of event relative to trigger position (if it exists).
PrePad - Pre-pad bits in burst. Displayed only when decoding Words, not Bits. If value is zero, column
will not appear.
Data - Actual data bits in packet.
PostPad - Post-pad bits in burst. Displayed only when decoding Words, not Bits. If value is zero, column
will not appear.
IFG - Inter-frame Gap bits.
Status - Information about the burst of transitions decoded.
8b/10b and 64b/66b Table Columns
You may display these columns on the 8b/10b or 64b/66b result table:
Time(µs) - Identifier showing data type and parameter association. Typically shown as octal numbers.
Data - Source/Destination identifier.
Length - Bits 29 - 11.
RD - Sign/Status Matrix.
Primitive - Primitive used for Symbolic decoding.
Data (symbolic) - Characters in a Symbolic decode.
Export Decode Result Table
You can export the decode result table data to a .CSV file.
Export files are by default created in the Xstream\Applications\ folder, although you can
choose any other folder on the oscilloscope, or any external drive connected to a host USB port. The
data will overwrite the last export file saved in the protocol directory, unless you enter a new filename.
To export the result table:
1. Press the Front Panel Serial Decode button, or choose Analysis > Serial Decode, then open the
Decode Setup tab.
2. Optionally, touch Browse and enter a new File Name and output folder.
3. Touch the Export Table button.