Teledyne LeCroy PP066 - Manual (Page 13)

Operator’s Manual
922225-00 Rev A 11
Certifications
This section certifies the probe’ Safety and Environmental compliance.
EC Declaration of Conformity - Safety
The probe meets intent of EC Directive 2006/95/EC for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 031: Safety requirements for
hand-held probe assemblies for electrical measurement and test.
Environmental Compliance
E ND -O F -L IFE H ANDLING
The probe is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2002/96/EC and 2006/66/EC on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The probe is subject to disposal and recycling regulations that vary
by country and region. Many countries prohibit the disposal of
waste electronic equipment in standard waste receptacles. For
more information about proper disposal and recycling of your
Teledyne LeCroy product, please visit teledynelecroy.com/recycle.
R
ESTRICTION OF
H
AZARDOUS
S
UBSTANCES
(R
O
HS)
The probe conforms to 2011/65/EU RoHS2 Directive based on the fact it is
classified as an Industrial Monitoring and Control Instrument (per Article 4,
Paragraph 24), and these products and associated accessories are exempt from
RoHS compliance until 22 July 2017 (per Article 4, Paragraph 3).