Teledyne LeCroy PP018 - Manual (Page 6)

PP017/PP018 Passive Probe
4 920876-00 Rev A
EC Declaration of Conformity
Compliance was demonstrated to the specification as listed in the Official Journal
of the European Communities: Low Voltage Directive 2006/95/EC.
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control and laboratory use – Part 031: Safety requirements for
handheld probe assemblies for electrical measurement and test.
General Safety Information
To avoid personal injury and to prevent fire or damage to the probe or any
product connected to it, review and comply with the following safety
precautions.
Using the probe and/or the test instrument it is connected to in a manner
not specified by the manufacturer may impair the protection mechanisms.
Connect to properly grounded instruments. Use only with test instruments
having their BNC input connected to earth ground. Do not connect the probe
ground terminal to any point which is at a potential other than earth ground.
Do not disconnect the probe from instrument during measurement.
Connect the probe to the measurement instrument before connecting the
probe to the test circuit.
Do not apply to the input any potential that exceeds the maximum rating
of the probe. Use only the accessories provided with the probe.
Comply with voltage derating curve. When measuring higher frequency
signals, be sure to comply with the Voltage vs. Frequency Derating Curve.
Do not remove probe casing. Removal of the probe’s casing may expose you
to electric shock.
Do not use if any part is damaged. All maintenance should be referred to
qualified service personnel only.