Teledyne LeCroy CP031 - Manual (Page 24)

CP031 Current Probe
18 923362-00 Rev A
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in accordance with EN61326-1:2006
and EN61326-2-1:2006.
A USTRALIA / N EW Z EALAND C ONTACTS :
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC Declaration of Conformity
– Low Voltage
The probe meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was demonstrated
to the following specifications as listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 1: General requirements
EN 61010-2:032:2002 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 2-032: Particular requirements for hand-held and hand-manipulated current
sensors for electrical test and measurement
Environmental Compliance
End-Of-Life Handling
The probe is marked with this symbol to indicate that it complies with the applicable
European Union requirements to Directives 2002/96/EC and 2006/66/EC on Waste Electrical
and Electronic Equipment (WEEE) and Batteries.
The probe is subject to disposal and recycling regulations that vary by country and region.
Many countries prohibit the disposal of waste electronic equipment in standard waste
receptacles. For more information about proper disposal and recycling of your Teledyne
LeCroy product, please visit teledynelecroy.com/recycle.
Restriction of Hazardous Substances (RoHS)
The product and its accessories conform to the 2011/65/EU RoHS2 Directive, as it has been classified as
Industrial Monitoring and Control Equipment (per Article 3, Paragraph 24) and is exempt from RoHS
compliance until 22 July 2017 (per Article 4, Paragraph 3).