System Sensor DECAL-R, -RC, -W and -WC - Manual

SpectrAlert Advance
Plain Model Decals
INSTALLATION AND MAINTENANCE INSTRUCTIONS
3825 Ohio Avenue, St. Charles, Illinois 60174
1-800-SENSOR2, FAX: 630-377-6495
www.systemsensor.com
Note: This product is only for use with Plain (-P) SpectrAlert Advance models.
Notice: This manual shall be left with the owner/user of this equipment.
Note: This product may be installed with both indoor and outdoor models.
GENERAL DESCRIPTION
For installation with SpectrAlert Advance plain (-P) strobes, horn strobes, and
speaker strobes. Decals can also be used on standard horns and speakers. The
accessory decals allow for flexibility in the field. Each set of decals ship with
decals for 5 units. Wall models include 10 decal sheets and ceiling models
include 15 decal sheets. Each set of decals include FIRE, ALERT, EVAC and
AGENT as options. Decals are offered in red and white for both wall and
ceiling devices. INSTALLATION:
1. Cut desired strip of lettering from the sheet.
2. Apply pressure to the letter on the paper side.
3. Slowly remove the clear plastic backing one letter at a time.
4. Letters should remain adhered to the white paper backing. If letters
remain adhered to clear backing, repeat set 2.
5. Apply letters with white paper backing onto clean surface of unit. Apply
pressure with finger along the length of the lettering.
6. Slowly remove white paper backing one letter at a time.
I56-3643-000
SPECIFICATIONS
Operating Temperature:
-40° F to 151° F (-40° C to 66° C)
Application Temperature: 40° F to 100° F
Cure Time: 72 Hours
For use with models DECAL-R, DECAL-W, DECAL-RC, DECAL-WC
FIGURE 1: WALL DECAL
A0431-00
FIGURE 2: CEILING DECAL
A0432-00
SS-110-005 1 I56-3643-000
©2010 System Sensor