Staub Electronics EP-400-NMC EPISODE - RACK MOUNT UPS NETWORK MANAGMENT CARD User Manual
Page 6
Remote Management System
6
Definitions for LED Indicators
Link LED color
Condition
Off
The Remote Management Card is not connected to the Network/
or the UPS is off
On(Yellow)
The Remote Management Card is connected to the Network
TX/RX LED color
Off
The Remote Management Card power is off
On(Green)
The Remote Management Card power is on
Flash
- Receiving/transmitting data packet
- Reset finished
Step 2. Configure the IP address for the Remote Management Card.
Method 1: Using the Power Device Network Utility Tool
1. Install the Power Device Network Utility Tool from the included CD. It is located on the CD in
the \tools\network folder. Double click the “Power Device Network Utility” installation file,
“Setup.msi” to begin the installation.
2. After installation is complete, run the “Power Device Network Utility” program. Under “All
Programs, Select “Power Device Network Utility”.
3. The main dialog of the “Power Device Network Utility Tool” program is shown in Figure. 1.
The
configuration tool will display all Remote Management Cards of present on the same
network. The "Refresh" button is used to search the entire local network for Remote
Management Card.
○
○
○
○
1 Ethernet connector
○
○
○
○
2 LINK Indicator
○
○
○
○
3 RX/TX Indicator