Staub Electronics EA-MR-AW-RVC-100 EPISODE ALL-WEATHER IMPEDANCE MATCHING VOLUME CONTROL User Manual
Owner’s manual, Volume control, Ea-mr-aw-rvc-100
VER 100422
OWNER’S MANUAL
>>
EA-MR-AW-RVC-100
Volume Control
Lifetime Limited Warranty
Episode
®
Multi-room accessories have a Lifetime Limited Warranty. This warranty
includes parts and labor repairs on all components found to be defective in
material or workmanship under normal conditions of use. This warranty shall not
apply to products which have been abused, modified or disassembled. Products
to be repaired under this warranty must be returned to SnapAV or a designated service
center with prior notification and an assigned return authorization number (RA).
Lifetime
The Episode
®
EA-MR-AW-RV C-100 Volume Control has a unique adjustable design
which allows it to be used as an impedance matching stereo volume control
when 2x, 4x, or 8x switch positions are selected, or as a standard stereo
non-impedance matching volume control when 1x switch position is selected
(Note: 1x position is for use with impedance matching speaker selector or other
impedance matching device). When the impedance matching switch positions
are selected, this design enables you to connect up to 8 pairs of 8 ohm speakers
or 4 pairs of 4-ohm speakers to an 8 ohm stable amplifier and operate them
simultaneously without the fear of amplifier overload, eliminating the need for
a speaker selector or other impedance matching device.
Mounting
1. Follow the mounting instructions included with the Episode
®
EA-MR-AW-RVC-100 enclosure.
Operational Check
1. After making all connections, check for proper operation. Switch the system
to the ON position. Using either the television or music, slowly increase the
volume on the amplifier/receiver to mid-position. Now, slowly rotate the
volume control knob from its minimum position towards its maximum
position. You should hear sound emanating from the speakers, increasing
in volume as you rotate the volume control knob through its twelve steps.
Select the level of sound that is desired. If no sound is heard from any or all
speakers, switch the system OFF immediately and check for open or loose
connections, wrong polarity, or shorts in the wires.