SP / Silicon Power Sky Share S10 - Manual (Page 27)

27
11. Enable/Disable Wi-Fi Function
Wi-Fi function of Sky Share S10 is enabled in the default setting whenever power-on.
This helps end-user to use Sky Share S10 immediately without any setup. If you don’t
use Wi-Fi function of Sky Share S10, you may power-off your camera to save battery
power consumption. Or, you may disable Wi-Fi of Sky Share S10 and enable Wi-Fi
again whenever you need.
Disable Wi-Fi function:
Step 1: Switch your camera to the pre-view mode
Step 2: Find the default “Wi-Fi OFF” photo in the pre-view mode.
Fig. 22 Default Wi-Fi OFF Photo
Step 3: Delete the default “Wi-Fi OFF” photo in the pre-view mode.
Wi-Fi function of Sky Share S10 will be disabled immediately.
Note: You have changed the Wi-Fi default setting to Wi-Fi OFF. Whenever you want
to use Wi-Fi function, you will need to enable Wi-Fi function first.
Enable Wi-Fi function:
Step 1: Switch your camera to the pre-view mode
Step 2: Find the default “Wi-Fi ON” photo in the pre-view mode