Apple Macintosh Performa 570 series - Manual (Page 100)

Installing a communications card (Macintosh Performa 570
series only)
1 Remove the communications card from its static-proof bag.
Hold the card by its top edge to avoid touching the connector on the bottom of
the card.
2 Align the card over the communications slot.
The communications slot is the rightmost slot on the logic board.
3 Press down on the card until the connector is solidly in place.
Don’t force the card. If you meet resistance, pull the card out and try again.
To see if the card is properly connected, lift it gently. If it resists and stays in
place, it’s connected.
Align the card
over this slot.
92 Appendix B