LevelOne WHG-1000 - Manual (Page 115)

WHG-1000 300Mbps Wireless PoE Hotspot Gateway
User's Manual
115
 ARP Table Information : Select “ARP Table Information” on the drop-down list to display ARP table.
ARP associates each IP address to a unique hardware address (MAC) of a device. It is important to have a unique
IP address as final destination to switch packets to.
 Bridge Table Information : Select “Bridge Table Information” on the drop-down list to display bridge table.
Bridge table will show Bridge ID and STP's Status on the each Ethernet bridge and its attached interfaces, the
Bridge Port should be attached to some interfaces (e.g. eth0, eth0.vlan_tag, ath0~ath7).
 Bridge MACs Information : Select “Bridge MACs Information” on the drop-down list to display MAC table.
This table displays local MAC addresses associated with wired or wireless interfaces, but also remember non-local
MAC addresses learned from wired or wireless interfaces.
Ageing timers will be reset when existing MAC addresses in table are learned again or added when new MAC
addresses are seen from wired or wireless interfaces as well. When time runs out for a particular entry, it will be
pruned from the table. In that situation, switching packet to that particular MAC address will be dropped.