LevelOne EAP-200 - Manual (Page 72)

72
(b)7.4.2 Backup & Restore
This function is used to backup and restore the EAP-200 settings. The EAP-200 can also be restored to
factory defaults using this function. It can be used to duplicate settings to other access points (backup
settings of this system and then restore on another AP).
Backup & Restore Page
•
Reset to Default:
Click Reset to load the factory default settings of EAP-200. A pop-up Page will appear to reconfirm
the request to reboot the system. Click OK to proceed, or click Cancel to cancel the reboot request.
Reboot Confirmation Prompt
A warning message as displayed below will appear during the reboot period. The system power must
be kept turn on before the completion of the reboot process.
The System Overview page will appear upon the completion of reboot.
•
Backup System Settings: Click Backup to save the current system settings to a local disk such as
the hard disk drive (HDD) of a local computer or a compact disc (CD).
•
Restore System Settings: Click Browse to search for a previously saved backup file, and then click
Upload to restore the settings. The backup file will replace the active configuration file currently
running on the system.
After network parameters have been reset / restored, the network settings of the administrator PC
may need to be changed to ensure that the IP address of the administrator PC is on the same subnet
mask as the EAP-200.