LevelOne WCS-2010 - Manual (Page 50)

44
Preset Function Area
”Enable IR control” Checking this box allows the Administrator to enable the IR controller
to move the aim of the camera. To allow controls only through URL commands or web
pages, leave this box unchecked.
”Current position”, If the User wants to save the current view as a preset location, enter a
name for each of the current video view at “current position” and click on the “Add” button.
The camera allows for 20 preset locations.
”Preset position” This keeps a list for preset positions. Clicking on the “Delete” button
will remove the current selected position from the preset list.
”Dwelling time” The value set here specifies:
1. The stop time of each preset location during auto patrol of the Network Camera.
2. The stay time at the most left and the most right positions when the Network Camera is
doing auto panning.
”Patrol selection”, After the User has saved a list of preset positions, the “Preset locations”
box will also keep a list of the preset positions. And once the “Select>” button is clicked, the
“Selected location” box will keep a list of the patrol stops. The “Remove” button removes
the preset position from the patrol stops. The “UP”, “DOWN” buttons adjust the order of the
patrol stops. Several preset positions can be added to the patrol stops. The camera can
accept up to 40 patrol stops.
“Save” button
The button is valid for “Pan speed”, “Tilt speed”, “Auto pan/patrol speed”, “Enable IR
control”, “Dwelling time” and “Patrol selections”. In other words, after changing these
settings, and the “Save” button is not clicked, the new setting of the camera will not take
effect.