LevelOne WCS-2010 User Manual

Page 43

“Return email address” The return email address used in the event the mails fail to be
sent out.

FTP

“Local FTP server port” This can be other than the default Port 21. The user can change
this value from 1 to 65535. After the change, the external FTP client program must
change the server port of connection accordingly.
“1st FTP server” The domain name or the IP address of the external FTP server. The
following user settings must be correctly configured for remote access.
“1st FTP user name” Granted user name on the external FTP server.
“1st FTP password” Granted password on the external FTP server.
“1st FTP remote folder” Granted folder on the external FTP server. The string must
conform to that of the external FTP server. Some FTP servers cannot accept preceding
slash symbol before the path without virtual path mapping. Refer to the instructions for the
external FTP server for details. The folder privilege must be open for upload.
“Primary FTP passive mode” The Network Camera is located inside the network
protected by a firewall, data connection for FTP may be prohibited. By selecting passive
mode, the FTP can bypass the rule and allow snapshot upload to proceed. If the passive
mode is selected, the Network Camera can automatically attempt for active mode, if the
external FTP server does not support passive mode.
“2nd FTP server” The domain name or IP address of the backup external FTP server.
“2nd FTP user name” Granted user name on the backup FTP server.
“2nd FTP password” Granted password on the backup FTP server.
“2nd FTP remote folder” Granted folder on the backup FTP server.
“Secondary FTP passive mode” Passive mode setting for the backup FTP server.

Some invalid settings may cause the system failing to respond. Change the

configuration only if necessary and consult with your network supervisor or
experienced users for correct settings. Once the system has lost contact, refer to
Appendix A for reset and restore procedures.