KB Electronics KBPC-240D - Manual (Page 19)

16
C. Signal Isolator (Model KBSI-240D, P/N 9431) – Signal isolation is required when a
remote nonisolated analog signal is to be used. Provision is made to install Model KBSI-
240D on 4 bosses inside the front cover. The unit accepts a variety of voltage and current
signals.
Note: Foward-Brake-Reverse Switch (P/N 9339) cannot be installed with Signal
Isolator.
D. Auto/Manual Installation Kit (P/N 9377) – This kit facilitates mounting of KBSI-240D
Signal Isolator into KBPC-240D. Contains Auto/Man Switch and necessary wiring and
hardware. (KBSI-240D, P/N 9431 purchased seperately).
E. ON/OFF AC Line Switch (P/N 9341) – This option is desirable if a positive AC Line
disconnect is required. The switch can be installed in lieu of the Start/Stop Switch (which
can be easily removed) or in place of the Run-Stop-Jog or the Forward-Brake Reverse
Switch. Installation is made via quick-connect terminals.
F. RFI Filter (Model KBRF-200A, P/N 9945A) – The KBRF-200A meets the requirements
of CE directives pertaining to RFI filtering.
G. Electronic Forward-Brake-Reverse (APRM-PC P/N 9378) – The APRM-PC provides
electronic reversing with solid state dynamic braking. Plug reversing is eliminated with
KB’s patented APRM ® . The Unit is supplied with a FWD-BRK-REV toggle switch;
however, it can also be switched with an external switch or relay.