Gilderfluke&Co DMX-512 Input DC Dimmer - Manual (Page 6)

Lg-DMX/DC ʻTestʼ Button
The ‘Test’ button is used to manually turn on and off the outputs of the Lg-DMX/DC to test for wiring
problems or check for burnt out lamps. Each time the ‘test’ button is pressed, it advances to the next test.
If DipSwitch 4 is ‘Off’, then all outputs will be turned off while any of the outputs are ‘under test’. If
DipSwitch 4 is ‘On’, then all outputs that are not ‘under test’ will remain at the levels set by the incoming
DMX-512.
On version 3.0+ Lg-DMX/DC, Dipswitches #5 and #6 set the level of brightness the tests are run at, or
disable the ‘test’ function completely (both ‘on’).
On each sequential push of the ʻTestʼ button:
1. ‘Test’ Button must be held for approximately three seconds on this initial push. All outputs
are turned ‘Off’. ‘Test’ LED begins flashing. If the test won’t start, check that Dipswitches #5
and #6 are not both ‘on’. This will disable the ‘test’ function on v3.0+ Lg-DMX/DC.
2. Output #0 is turned on (v3.0+ output level depends on Dipswitches #5 and #6).
3. Output #1 is turned on (v3.0+ output level depends on Dipswitches #5 and #6).
4. Output #2 is turned on (v3.0+ output level depends on Dipswitches #5 and #6).
5. Output #3 is turned on (v3.0+ output level depends on Dipswitches #5 and #6).
6. Output #4 is turned on (v3.0+ output level depends on Dipswitches #5 and #6).
7. Output #5 is turned on (v3.0+ output level depends on Dipswitches #5 and #6).
8. Output #6 is turned on (v3.0+ output level depends on Dipswitches #5 and #6).
9. Output #7 is turned on (v3.0+ output level depends on Dipswitches #5 and #6).
10. All Outputs are turned on (v3.0+ output level depends on Dipswitches #5 and #6).
11. Outputs #0, #2, #4 and #6 are turned on (v3.0+ output level depends on Dipswitches #5 and
#6).
12. Outputs #1, #3, #5 and #7 are turned on (v3.0+ output level depends on Dipswitches #5 and
#6).
13. Test mode is ended and the Lg-DMX/DC is returned to normal operation. ‘Test’ LED stops
flashing.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / September 10, 2012 9:58 AM / page 6 of 12