Sonnet Technologies Tango 2.0 FireWire_USB 1.1_2.0 PCI Combo Adapter Card - Manual (Page 5)

5
Installation Steps—Windows PCs
This page covers the procedure for installing for the Tango 2.0 card into a
Windows PC. If you have a Mac OS computer, return to page 2.
Installation Preparation
Prior to installing Tango 2.0 into your system, you should read the section in
your computer’s user manual that addresses PCI card installation.
Tango 2.0 Card Installation Steps
1. Shut down your computer.
2. Open your computer to access its expansion card area (PCI slots); refer to
your computer’s user manual for specifi c information.
3. Remove the Tango 2.0 card from its packaging.
4. Locate an available PCI slot inside your computer and, if present, remove
its port access cover from the rear of the computer.
5. Install the Tango 2.0 card into the PCI slot; make sure the card is fi rmly
seated and secured.
6. Close your computer and carefully replace its cover.
FireWire/USB Driver Installation Steps
The following section covers the installation of FireWire and USB driver soft-
ware in a Windows PC. If you have a Mac OS computer, go back to page 2 to
fi nd Mac OS driver installation information.
Windows XP
1. Turn on your computer; during Windows startup, Found New Hardware
pop-ups will appear.
2. When the Found New Hardware Wizard window appears, click Next.
3. When the Completing the Found New Hardware Wizard window appears,
click Finish.
4. When the next Found New Hardware Wizard window appears, click Next.
5. When the Completing the Found New Hardware Wizard window appears,
click Finish.
6. A Found New Hardware pop-up will appear, stating that the software for
the new device has been installed; your installation is complete.
Windows 2000
1. Turn on your computer; during Windows startup, several New Hardware
Found windows will appear, and the appropriate drivers will be installed.
Your installation is complete.
For
Windows
Support Note: High-speed USB 2.0 is supported only under Windows
2000 with Service Pack 3 installed or Windows XP with Service Pack 1
or later installed. However, USB 2.0 peripherals are backward-compatible, and
Tango 2.0 will support them at USB 1.1 speeds (12 Mb/sec. maximum) when
they are used under any other supported version of Windows.