Sonnet Technologies Fusion QR (Without Drives) - Manual (Page 5)

1 – Fusion QR Features
1
1 – Power Indicator
This blue LED lights when the Fusion QR is powered.
2 – Presence, Activity, and Fault Indicators — Drives A – C
These LEDs indicate the ready state (solid green), read and
write activity (flashes green), and fault status (OFF or red) for
drives A – C. An LED will remain off if the corresponding
drive is not recognized, and will turn red if the drive is
recognized but can’t be used.
3 – Mode Change Confirmation; Drive D Presence, Activity,
and Fault Indicator
When setting the drive mode, this LED stays off, or lights
green, orange, or red depending on the mode selected. It also
indicates drive D’s ready state (solid green), read and write
activity (flashes green), and fault status (OFF or red). The LED
will remain off if the corresponding drive is not recognized,
and will turn red if the drive is recognized but can’t be used.
4 – Drive Mode Selection Switch
Select the drive mode setting using this switch.
5 – Erase and Set Mode Switch
Press and hold this switch for three or more seconds upon
powering the system to activate the selected drive mode.
6 – Drive Trays
To remove a drive tray, turn the thumbscrew counter-clockwise
until it pops out, and then pull out the entire tray. To place a
drive tray, insert it into the drive bay until it stops, push in the
thumbscrew until it stops, and then turn it clockwise until it
stops;
do not overtighten the thumbscrew.
7 – Inner Chassis Lock Switch
Slide this switch to the left to allow you to remove and replace
the front cover.
A – Security Slot
This slot works with Kensington ® brand and similar security
locks to secure the Fusion enclosure and deter theft.
B – Power Switch
C – Locking eSATA Interface Port
This port is compatible with the included Sonnet locking
eSATA data cable and standard eSATA data cables.
D – FireWire 800 Interface Ports
In addition to FireWire 800, these ports support FireWire
400 connections on computers and adapter cards when used
with a FireWire 400-to-FireWire 800 adapter or adapter cable.
E – USB 3.0 Interface Port
F – 19V DC Power Socket
Connect the included DC power adapter between this socket
and the included power cord.
❺
❻ ❻ ❻
❼
❻
❹ ❸ ❷ ❷ ❷ ❶
A
B
C
D D E F