Sonnet Technologies Fusion QR (Without Drives) - Manual (Page 13)

9
6 – Status LED Indications
System Powered, No Drive Activity
When the Fusion QR is powered on, and no data is being
written to or read from the drives, the Power and Drive LEDs
stay on
(Figure 20).
Drive Activity
When data is being read from or written to a drive, its
corresponding LED will flash
(Figure 21).
Drive Not Recognized
When a drive LED stays off while the others remain lit, the
corresponding drive(s) is not recognized
(Figure 22). There
are a few possible causes for a drive to not be recognized,
including: the corresponding drive module is not plugged
securely into the enclosure or the drive itself has failed. If
reseating the drive does not fix the situation, replace the
drive as soon as possible.
RAID 5 or RAID 10 Rebuild
After inserting a drive into the QR enclosure to replace
a failed drive from a RAID 5 or RAID 10 group, the
corresponding LED alternately flashes orange and green
until the RAID has been rebuilt
(Figure 23). Once the
rebuild is complete, the LED returns to normal operation.
Bad Drive Detected
When the QR determines a drive has gone bad, the
corresponding LED lights red continuously
(Figure 24).
Causes for this condition include the drive’s failure to spin
up, too many physical errors on the drive, drive BIOS failure,
etc. Replace the drive as soon as possible.
Figure 20
LEDs stay on
System Powered, No Drive Activity
Figure 21
Drive Activity (Data Reads and Writes)
Figure 22
Drive Not Recognized
LED stays off
Figure 23
Figure 24
RAID 5 or RAID 10 Rebuild
Bad Drive Detected
LED alternately flashes orange and green
LEDs flash
LED lights RED