SKC Limited EPAM-7500 - Manual (Page 23)

2-5
Setting the Alarm
Introduction An audible alarm can be set to alert the worker of approaching threshold
limits.
Alarm settings The concentration level must be set to the defined agency standard for the
particulate type being sampled.
Note: See Appendix B for a partial listing of the most common dust
particulates and their corresponding concentration levels.
Using the alarm Follow the steps in the table below to set the alarm level.
Step Action
1 Select Monitor graphic from the Main Menu.
2 Select Alarm graphic.
3 Enter the appropriate concentration level using the table below.
To... Press...
Increase the value of the
selected digit. < Scroll the bar to the
or press on the concentration
number and enter the value you
would like to set. >
Decrease the value of the
selected digit. < Scroll the bar to the
or press on the concentration
number and enter the value you
would like to set. >
5 Click on Green check mark to accept the alarm set point.
To run unit with alarm, after setting alarm click on the alarm
graphic. This will remove the red X on the alarm. Press the alarm
again to put the red X back on mute the alarm.
Result: The alarm has been set.