SKC Limited EPAM-7500 - Manual (Page 22)

2-4
Setting the Date and Time
Introduction The date and time are pre-set by the factory to Eastern Standard Time and are
maintained by an internal clock. It may be necessary to change the date and
time due to local time zones or daylight savings time.
Note: It is important that the system date and time are correct for accurate
record keeping.
Date and Time
settings Time is entered and displayed in military time format.
Date is entered and displayed in European format (i.e., 03-DEC-2011).
View settings Follow the steps in the table below to check the unit’s date and time.
Step Action
1 Select Settings from the Main Menu.
2 Date/Time is shown on the first screen and in the first three boxes.
Change settings Follow the steps in the table below to change the unit’s date and time.
Step Action
1 Select Settings from the Main Menu.
2 Press on time zone drop down menu and select your timezone.
3 Press on the date drop down menu and select the year, month, and
date.
4 Press on the hour position on the time box.
To... Press...
Increase the value of the selected digit. < >
Decrease the value of the selected digit. < >
Change minutes or seconds Press on minutes or
seconds and change the
value as described
above.
5 Press Green check mark when the correct information has been
entered.