SKC 226-119 Sorbent Sample Tubes User Manual
Certifi cate of quality
Cat. Nos. 226-119 and 226-119-7
Form 37575 Rev 1305
Acetone ASTM
D5197
Aldehydes ASTM
D5197
Aldehydes EPA
TO-11A
Formaldehyde ASTM
D5197
Formaldehyde EPA
IP-6A
Formaldehyde EPA
TO-11A
Formaldehyde NIOSH
2016
Glutaraldehyde NIOSH
2532
Hexanaldehyde (hexanal)
ASTM
D5197
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which provides SKC’s sole
liability and the buyer’s exclusive remedy. To view the complete SKC Limited Warranty and Return
Sorbent:
Silica Gel coated with
2,4-Dinitrophenylhydrazine
Tube Holder: Type B
Storage: Store
at
≤ 39.2 F (4 C) before use.
After sampling, store at ≤ 39.2 F (4 C).
Expedite shipping of samples to the laboratory.
Friday shipments are not recommended.
Certifi cate of Quality
SKC is an ISO 9001 registered
manufacturing company.
For compliance sampling, use these tubes as specifi ed in a validated sampling method. It is the user’s
responsibility, employing a suitable method, to establish appropriate safety and health practices and
to determine the applicability of regulatory limitations before use. The user should adjust the sampling
procedures to specifi c conditions and should test tubes to ensure that the desired results will be obtained.
The SKC Certifi cate of Quality assures that these sorbent tubes have been manufactured to meet or
exceed the requirements for sorbent purity, sample collection and retention, storage stability, and
desorption effi ciency for the following chemical hazards and analytical methods published by NIOSH,
OSHA, EPA, or ASTM: