SKC 228-9530 QuickTake 30 - Manual (Page 19)

18
Advanced Setup
Intermittent Sampling
Intermitt ent Sampling allows the pump to be programmed to run for a specifi c
number of minutes up to 999, to shut off for a programmed
length of time, and to continue sampling on and off for a
predetermined number of cycles (e.g., program the pump
to run three cycles (n) of 15 minutes each (r) with a fi ve-
minute delay (d) between each cycle).
Entering Intermittent Sampling Mode
Press  or  to scroll to Intt . Press

to enter the intermitt ent sampling setup mode.
Setting Run Time (r)
1. Press  or  to increase or decrease run time. The display will fl ash. If no
change to run time is desired, press

to move to delay time.
2. When fi nished, press

. Stor will fl ash on the display.
To save the new sett ing: Press [

]. Press

to move
to delay time setup.
To ignore the new sett ing: Press

. Display will move
to the delay time.
If displayed values are not changed, the fl ashing Stor
will not appear and pressing

will move the display
to the next parameter to be set.
Digital display:
Intermittent Sampling
Digital display:
Set run time
Setting Delay Time (d)
1. Press  or  to increase or decrease delay time. The
display will fl ash. If no change to delay time is desired,
press

to move to number of cycles.
2. When fi nished, press

. Stor will fl ash on the display.
To save the new sett ing: Press [

]. Press

to move
to number of cycles setup.
To ignore the new sett ing: Press

. Display will move to the number of cycles.
Digital display:
Set delay time