SecurityMan Panbase - Manual (Page 13)

2) Press the left button (ON/OFF button) again and the Pan
Base will stop.
3) While rotating, press the right button (Rotation button) at
any time to change the rotating direction.
4) If you want to turn on or turn off the Pan Base, press the
left button (ON/OFF button) twice respectively.
5) Point the remote control towards the Pan Base antenna.
The remote distance should be in specification range (up to
50 meter line of sight).
6) The 12V DC power cable (for security camera) must be
stretched out to allow the camera to rotate properly.
7) To install, place the nylon gel areas of the Pan Base bot-
tom to the desired location. Then screw and tighten the
bolts accordingly.
Troubleshooting
If the remote control and Pan Base do not work, please
check the following:
1) is the battery inside the remote control drained or is the
battery installed correctly?
2) is the antenna extracted out and away from the remote
control?
3) ensure that the receiving antenna on the Pan Base is not
circled around the power cord?
4) if the Pan Base is connected properly with correct power
adapter?
5) if the remote control is used within the remote control
range (up to 50 meter line of sight)?
13