Schlage BE469NX User's Guide - Manual (Page 9)

9
ENGLISH
Changing the Alarm Mode
After you power on the alarm, it will be preset to the Forced Entry mode, by default. If you want
to change the mode, follow these simple steps:
L The alarm must first be powered on before changing the alert setting!
Press and hold.
Release after
first flash (about
2 seconds)
Activity
Press and release the
button until the LEFT
light is lit.
Tamper
Press and release
the button until the
MIDDLE light is lit.
Forced Entry
Press and release the
button until the RIGHT
light is lit.
DEFAULT SETTING
L The lock will beep when it leaves
Programming Mode.
Adjusting the Sensitivity Level
Each alarm mode is preset to a sensitivity level of three. If your alarm is sounding too frequently,
or not frequently enough, try changing this setting.
L You do not need to adjust this setting unless the alarm is sounding too frequently or not
frequently enough.
L If you change the alarm mode, the sensitivity will revert back to the default setting.
Press and hold Press and release Press and release again
Release after third flash
(about 10 seconds).
Wait for 1 - 5 flashes/
beeps. The number of
flashes/beeps matches
the sensitivity setting.
until the number of
flashes/beeps matches
the desired sensitivity
setting.
L Each time you press and release the button, the alarm will beep/flash
the same number of times as the setting level.
SENSITIVITY
1 2 3 4 5
default
Number of Flashes/Beeps
PROGRAMMING THE ALARM