Rivers Edge RE625 Onset - Manual (Page 6)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 CST 6
Operator's Manual
Rivers Edge® One-Man Ladder Stands, Onset and Onset XT
5. Attach the tree blade weldment (SL67) to the rear end of ladder side
rails using (4) provided 1/4-20 x 2-1/4” bolts, locknuts and steel
washers. SEE fIGuRE 4. The tree blade will be a tight fit in order
to correctly span the seat properly. You must now tighten all nut
and bolt assemblies. Be sure not to over tighten or crush tubing
when tightening!
6. Insert one side of the base extension weldment (410044) into the
base extension rail tube (410040) and secure with (1) provided 1/4-
20 x 1-1/2” bolt, locknut and steel washer. SEE fIGuRE 5. This step
now makes this the "locking rung".
7. Take the factory assembled ladder sections and unfold them to their
full, deployed width. Insert the previously assembled base extension
into (1) 3-step ladder section (410032) and secure with (2) spring
lock pins. Handle of spring lock pins must be put to the outside of
the ladder side rails. SEE fIGuRE 5. This step now makes this the
bottom ladder section.
8. Sections are assembled on the ground in the following order; bottom
section (410032 ladder with assembled base extension [locking
rung]); second section (410035 ladder with stabilizer bar mount);
third section (410032 ladder); top section (assembled top platform
section). Make sure assembled ladder sections have the steps
positioned on the same side outward, away from tree for climbing.
SEE fIGuRE 6 AND fINIShED ONSET™ lADDER.
9. With all sections assembled together on ground, secure all sections
together using (6) provided spring lock pins. Handle of spring lock
pin must be put to the outside of ladder side rails. SEE fIGuRE 6. In
total, you should now have 8 spring lock pins on the ladder
assembly that are securing all sections together.
Figure 6
Figure 4
locknuts
tree blade
steel
washers
1/4-20 x 2-1/4" bolts
Figure 5
spring lock pins
base extension tube
base extension weldment
(locking rung)
bottom ladder
section
spring lock pin
1/4-20 x
1-1/2" bolts
locknuts
steel
washers