Ransburg AdaptaFlow Node Adapter A10159 - Manual (Page 25)

LN-9217-00.2
AdaptaFlow Node Adapter - Maintenance
MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE
The following basic troubleshooting can be performed by observing the Node Adapter front panel
displays. Also refer to the "Troubleshooting" section in the "AdaptaFlow 5000 Fluid Flow Control"
manual.
Active Active Active Active Active
LED LED LED LED LED
Description Description Description Description Description Possible Cause Possible Cause Possible Cause Possible Cause Possible Cause
ON
OFF
BLINK
OFF
OFF
Normal operation
Node Adapter not communicating
Node Adapter is not controlling
I/O
Node Adapter processor is not
active
No Node Adapter activity
------
1. RIO cable not connected
2. Incorrect dipswitch settings on Node
Adapter for Baud rate, Address or
Starting Quarter
3. Problem with PLC
1. PLC in program mode
2. Another Node with same address on
RIO
1. Hardware failure
1. No power to Node Adapter
2. Hardware failure
Adapter LED Indicators Adapter LED Indicators Adapter LED Indicators Adapter LED Indicators Adapter LED Indicators
CPU CPU CPU CPU CPU
LED LED LED LED LED
ON
ON
ON
OFF
OFF
2 2 2 2 2 2 2 2 2 2
TROUBLESHOOTING GUIDE
ARCHIVE