Ransburg AdaptaFlow Node Adapter A10159 - Manual (Page 10)

LN-9217-00.2
> Positions 6-8 pertain to the RS-422
port which is only used by qualified ITW
Ransburg representatives as a debug
tool. These settings do not effect normal
operation.
AdaptaFlow Node Adapter - Installation
INST INST INST INST INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
NODE ADAPTER SETUP NODE ADAPTER SETUP NODE ADAPTER SETUP NODE ADAPTER SETUP NODE ADAPTER SETUP
Jumpers E1 through E5 are factory set and should
not be changed. Refer to the "Installation" docu-
mentation for the correct switch settings.
Figure 2: Node Adapter Switch Settings Figure 2: Node Adapter Switch Settings Figure 2: Node Adapter Switch Settings Figure 2: Node Adapter Switch Settings Figure 2: Node Adapter Switch Settings
Last State
De-energized
Pos. 2 Pos. 2 Pos. 2 Pos. 2 Pos. 2
ON
OFF
Outputs Outputs Outputs Outputs Outputs
Outputs In Outputs In Outputs In Outputs In Outputs In
Program Mode
Program Mode Program Mode Program Mode Program Mode
NOTE NOTE NOTE NOTE NOTE
7 7 7 7 7
Pos. 8 Pos. 8 Pos. 8 Pos. 8 Pos. 8
RS-422 RS-422 RS-422 RS-422 RS-422
Address Address Address Address Address
RS-422 Address RS-422 Address RS-422 Address RS-422 Address RS-422 Address
Pos. 6 Pos. 6 Pos. 6 Pos. 6 Pos. 6 Pos. 7 Pos. 7 Pos. 7 Pos. 7 Pos. 7
OFF
OFF
OFF
OFF
ON
ON
ON
ON
OFF
OFF
ON
ON
OFF
OFF
ON
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
00
01
02
03
04
05
06
07
Always OFF
Position 1 Position 1 Position 1 Position 1 Position 1
57.6 KB
115.2 KB
230.4 KB
230.4 KB
Pos. 3 Pos. 3 Pos. 3 Pos. 3 Pos. 3
OFF
OFF
ON
ON
RIO Baud Rate RIO Baud Rate RIO Baud Rate RIO Baud Rate RIO Baud Rate
Select
Select Select Select Select
Pos. 4 Pos. 4 Pos. 4 Pos. 4 Pos. 4
Baud Baud Baud Baud Baud
Rate Rate Rate Rate Rate
OFF
ON
OFF
ON
Dip Switch Settings Dip Switch Settings Dip Switch Settings Dip Switch Settings Dip Switch Settings
ARCHIVE