Ransburg 9040 Classic Power Supply _NO2 Gun 76657-14, -142 - Manual (Page 8)

CP-97-03.6
9040 Classic for the No. 2 Process Handgun - Safety
4 4 4 4 4
A R E A A R E A A R E A A R E A A R E A
Tells where
hazards may occur.
H A Z A R D H A Z A R D H A Z A R D H A Z A R D H A Z A R D
Tells what the hazard is.
SAFEGUARDS SAFEGUARDS SAFEGUARDS SAFEGUARDS SAFEGUARDS
Tells how to avoid the hazard.
Improper operation or mainte-
nance may create a hazard.
Personnel must be properly
trained in the use of this equip-
ment.
Personnel must be given training in accordance
with the requirements of NFPA 33, Chapter 16,
2000 edition.
Instructions and safety precautions must be read
and understood prior to using this equipment.
Comply with appropriate local, state, and national
codes governing ventilation, fire protection, opera-
tion maintenance, and housekeeping. OSHA refer-
ences are Sections 1910.94 and 1910.107. Also
refer to NFPA 33, 2000 edition and your insurance
company requirements.
Always turn power to the power supply OFF, un-
plug the electrical cord from its outlet, and remove
the front panel fuse, before opening the power sup-
ply door. If necessary, lock the power supply out
so that it cannot be turned ON until the work is fin-
ished.
Whenever removing high voltage cables from
equipment, ground the contact end of the cable by
holding the cable such that the contact touches
earth ground for several seconds. Do not touch
the contact until it has been grounded. This will
reduce the possibility of residual charge causing
electrical shock.
The High Voltage Multiplier Assembly contains en-
ergy storage components that can cause serious
shock injury, and therefore is not field repairable.
Warranty will be voided if the High Voltage Multi-
plier seal is broken. If the High Voltage Multiplier
is defective contact your authorized Ransburg rep-
resentative for exchange or repair.
The High Voltage Multiplier and high voltage cable
contain significant capacitance that will store
charge. Allow approximately 10 seconds for this
charge to bleed off before opening the cabinet door
or removing the high voltage cable from the power
supply or spray gun.
General Use and General Use and General Use and General Use and General Use and
Maintenance
Maintenance Maintenance Maintenance Maintenance