Ransburg 9040 Classic Power Supply _NO2 Gun 76657-14, -142 - Manual (Page 13)

CP-97-03.6
9040 Classic for the No. 2 Process Handgun - Installation
9 9 9 9 9
INPUT CONNECTIONS INPUT CONNECTIONS INPUT CONNECTIONS INPUT CONNECTIONS INPUT CONNECTIONS
Plug the AC line cord into a properly grounded
AC outlet. Any extension of the AC line cord
MUST conform to the following:
• It must be properly connected to wire with
ground.
• It must be 14 gauge minimum.
• It must be less than 100 feet total length.
• It should be continuous (as few connections
as possible).
! For portable use, the 9040 Classic
No. 2 Power Supply comes factory wired
with an AC line cord. For permanent instal-
lations, conduit is generally required. How-
ever, if national and local codes permit, the
AC power may be supplied via the factory
installed line cord for permanent installations
also. If conduit is utilized, the power supply
wiring MAY be routed through an optional
explosion proof switch mounted on or near
the spray booth where it will be convenient
to the operator.
N O T E N O T E N O T E N O T E N O T E
Input Circuit T Input Circuit T Input Circuit T Input Circuit T Input Circuit Test est est est est
Prior to applying AC power to the Power Sup-
ply, the phase and ground of the AC receptacle
and/or extension cord MUST be tested using
the Circuit Tester, P/N 20868-00. If the circuit is
found to be faulty or out of phase, the circuit
MUST be corrected before operating the power
supply.
! Operation of the power supply on an
ungrounded or improper circuit can lead to
component failure or unsafe operation.
C A U T I O N C A U T I O N C A U T I O N C A U T I O N C A U T I O N
!!!!!
EXTERNAL EXTERNAL EXTERNAL EXTERNAL EXTERNAL
CONNECTIONS CONNECTIONS CONNECTIONS CONNECTIONS CONNECTIONS
! When connecting external control wires
to the 9040 Classic Power Supply, route the
wiring through the external wiring grommet
located on the side panel.
N O T E N O T E N O T E N O T E N O T E
High V High V High V High V High Voltage (HV) oltage (HV) oltage (HV) oltage (HV) oltage (HV)
Cable Connection Cable Connection Cable Connection Cable Connection Cable Connection
Remove the plastic protective plug from the HV
Cable Connector and squirt enough of the sup-
plied dielectric oil (70863-00) into the HV Tube
to cover the electrical contact point.
With a clean, dry cloth, wipe the end of the HV
Cable. Insert the HV Cable into the HV Cable
Connector and tighten the cable nut securely.
Safety Ground Safety Ground Safety Ground Safety Ground Safety Ground
Crimp the appropriate connector onto the
Ground Wire Assembly and install from the
power supply ground stud, located on the side
panel, to a true earth ground.
! Squirting dielectric oil (70863-00) down
the HV Tube significantly reduces corona
discharge that can cause deterioration of the
HV connection components.
N O T E N O T E N O T E N O T E N O T E
! The Ground Wire Assembly MUST MUST MUST MUST MUST be
connected from the Power Supply ground
stud to a true earth ground. DO NOT
DO NOT DO NOT DO NOT DO NOT
attach the ground wire from the Power
Supply to the part being coated. Damage to
the power supply will occur! Separate
ground wires MUST
MUST MUST MUST MUST be used for grounding
the part and the Power Supply.
C A U T I O N C A U T I O N C A U T I O N C A U T I O N C A U T I O N
!!!!!