Ransburg 9040 Classic Power Supply _NO2 Gun 76657-14, -142 - Manual (Page 15)

CP-97-03.6
9040 Classic for the No. 2 Process Handgun - Operation
1 1 1 1 1 1 1 1 1 1
OPERA OPERA OPERA OPERA OPERATION TION TION TION TION
! The electrical discharge which is
available from the charging electrode of the
applicator must not exceed 0.25 mJ of
energy. To achieve this limit, any flow of
energy from the paint supply through the
paint line to the gun electrode MUST
MUST MUST MUST MUST be
prevented by grounding the paint line at the
gun handle or body. Verify that the appli-
cator is actually grounded BEFORE
BEFORE BEFORE BEFORE BEFORE
operating it! (See the appropriate spray
gun manual.) If improper readings are
obtained, check that the power supply is
grounded (see "Ground Test Procedure" in
the "Maintenance" section of this manual).
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G
!!!!!
! The user MUST MUST MUST MUST MUST read and be familiar
with the "SAFETY" SECTION "SAFETY" SECTION "SAFETY" SECTION "SAFETY" SECTION "SAFETY" SECTION of this
manual and the Ransburg safety literature
therein identified BEFORE OPERATING
BEFORE OPERATING BEFORE OPERATING BEFORE OPERATING BEFORE OPERATING
the 9040 Classic power supply.
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G
!!!!!
THEOR THEOR THEOR THEOR THEORY Y Y Y Y OF OPERA OF OPERA OF OPERA OF OPERA OF OPERATION TION TION TION TION
-REFER TO FIGURE 10 -REFER TO FIGURE 10 -REFER TO FIGURE 10 -REFER TO FIGURE 10 -REFER TO FIGURE 10
Line Voltage (90-264 VAC) is applied to input
terminals 11PL-1 and 11PL-2 of 18 VDC Power
Supply 1SUP through the user supplied exhaust
fan and conveyor interlocks, fuse 1FU and ON/
OFF switch 1SW. Line voltage from ON/OFF
switch 1SW is also supplied to the input of the
24 VDC power supply 2SUP. The 24 VDC out-
put of the power supply is then supplied to
Figure 5: Operating Controls Figure 5: Operating Controls Figure 5: Operating Controls Figure 5: Operating Controls Figure 5: Operating Controls