Ransburg 9040 Classic HV Power Supply 77070-33 - Manual (Page 7)

CP-08-01 4 4 4 4 4
9040 Classic HV Power Supply - Safety
A R E A A R E A A R E A A R E A A R E A
Tells where hazards
may occur.
H A Z A R D H A Z A R D H A Z A R D H A Z A R D H A Z A R D
Tells what the hazard is.
S A F E G U A R D S S A F E G U A R D S S A F E G U A R D S S A F E G U A R D S S A F E G U A R D S
Tells how to avoid the hazard.
Explosion Hazard/ Explosion Hazard/ Explosion Hazard/ Explosion Hazard/ Explosion Hazard/
Incompatible
Incompatible Incompatible Incompatible Incompatible
Materials
Materials Materials Materials Materials
Halogenated hydrocarbon solvents
for example: methylene chloride
and 1,1,1,-Trichloroethane are not
chemically compatible with the
aluminum that might be used in
many system components. The
chemical reaction caused by these
solvents reacting with aluminum
can become violent and lead to an
equipment explosion. Aluminum is widely used in other spray application
equipment - such as material pumps, regulators,
triggering valves, etc. Halogenated hydrocarbon
solvents must never be used with aluminum
equipment during spraying, flushing, or cleaning.
Read the label or data sheet for the material you
intend to spray. If in doubt as to whether or not a
coating or cleaning material is compatible, contact
your material supplier. Any other type of solvent
may be used with aluminum equipment.
Improper operation or maintenance
may create a hazard.
Personnel must be properly trained
in the use of this equipment.
Personnel must be given training in accordance with
the requirements of NFPA-33.
Instructions and safety precautions must be read
and understood prior to using this equipment.
Comply with appropriate local, state, and national
codes governing ventilation, fire protection, operation
maintenance, and housekeeping.
Always turn power to the power supply OFF, unplug
the electrical cord from its outlet, and remove the
front panel fuse, before opening the power supply
door. If necessary, lock the power supply out so that
it cannot be turned ON until the work is finished.
Whenever removing high voltage cables from
equipment, ground the contact end of the cable by
holding the cable such that the contact touches
earth ground for several seconds. Do not touch the
contact until it has been grounded. This will reduce
the possibility of residual charge causing electrical
shock.
The high voltage multiplier assembly contains energy
storage components that can cause serious shock
injury, and therefore is not field repairable. Warranty
will be voided if the high voltage multiplier seal is
broken. If the high voltage multiplier is defective
contact your authorized ITW Ransburg representative
for exchange or repair.
The high voltage multiplier and high voltage cable
contain significant capacitance that will store charge.
Allow approximately 10 seconds for this charge to
bleed off before opening the cabinet door or removing
the high voltage cable from the power supply or
spray applicator.
General Use and General Use and General Use and General Use and General Use and
Maintenance
Maintenance Maintenance Maintenance Maintenance
ARCHIVE