Ransburg AquaTank - Manual (Page 10)

IS-99-01.4
AquaTank - Installation
7
INSTALLATION
1. Follow "Pressure Relief Procedure" described
in previous "Warning".
2. To add material to the AquaTank, remove lid
and pour directly into the container.
Mix and prepare material to be used according
to manufacturer’s instructions. Strain material
through a fine mesh screen to remove lumps, skin,
and foreign matter that might enter and clog fluid
passages and/or spray equipment.
AQUATANK INSTALLATION
(Refer to Figure 3)
3. Replace the lid assembly and tighten all
securing knobs.
4. Connect ground wire to true earth ground
(reference NFPA-70).
5. The air supply hose should be connected to a
regulated air source, which should include a
filter/water separator to remove air line
impurities.
> Pressure Relief Procedure: High pressure
can cause serious injury. Pressure is main-
tained in a pressure tank after the system
has been shut down. Before attempting
removal of fill plug or cover, pressure must
be relieved using the following steps:
• Ensure the power supply is turned OFF.
• Turn OFF the main air supply to the tank.
• BLEED OFF air in tank by pulling the air
relief valve stem, or use a relief valve at
the regulator. Wait until all the air has es-
caped through the valve before removing
the pressure tank cover or fill plug.
W A R N I N G
!
> Static electricity is created by the flow of
fluid through the pressure tank and hose. If
all parts are not properly grounded, sparking
may occur. Sparks can ignite vapors from
solvents and the fluid being sprayed.
> If static sparking, or slight shock is experi-
enced while using this equipment, stop spray-
ing immediately.
> Ground the pressure tank by connect-
ing one end of a 12-gauge minimum ground
wire to the pressure tank ground stud and the
other end to a true earth ground. Local codes
may have additional grounding requirements.
W A R N I N G
!
> Failure to ground may cause improper tank
function. The tank MUST BE grounded.
W A R N I N G
!
> Keep fingers clear of pinch point.
NOTE
> Use only recommended Ransburg ap-
proved fluid pail for this product. Failure to
use approved fill pail may defeat bleed
resistor function.
W A R N I N G
!