King Kooker 2607 Smoker/Oven/Stove - Manual (Page 14)

14
connectIon InstructIons
1. Check that your hose assembly valve is set to not allow gas flow. Turn the manual valve clockwise
until it stops. This is the OFF position.
2. Remove dust cap from cylinder valve. Save cap for use in storing. Screw propane cylinder into
regulator. Be careful not to cross thread. Hand tighten only. Refer to Figure 1, page 10.
3. Perform the Leak Test:
4. Before lighting the cooker, check that the venturi tube is free of obstruction and that the orifice is
properly threaded into the venturi tube as per the instructions on page 10. Both situations must
be corrected if necessary before lighting to prevent flashback.
lp gas cylInder InFormatIon
This appliance is manufactured for use with 1lb. (16.4 oz) lp gas cylinders. Important information to
remember about LP Gas cylinders include:
1. Always read and follow the cylinder manufacturer’s instructions.
2. Always check cylinder’s seals before use. Never use with damaged or missing seals. Discard cylinder if
dirt or rust particles are in valve area.
3. Do not store a spare LP gas cylinder under or near this appliance.
4. Disconnect the cylinder from the cooker for storage.
5. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust
cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps and plugs
may result in leakage of propane.
6. Store the cylinder out of the reach of children.
7. Do not carry or store the cylinder in the cooker bag.
8. Do not use or store the cylinder in a building, garage or enclosed area.
9. Always use the cylinder in the proper upright position for the proper vapor withdrawal. It should also be
stored and transported in the upright position.
10. Never refill a disposable cylinder. On average, a full 1lb. cylinder (16.4 oz) will give you two hours of
normal cooking with this appliance.
11. To discard of cylinder, contact local refuse hauler or recycle center. Never put in fire or incinerator. Do not
puncture.
always read and Follow these and the cylInder manuFacturer’s InstructIons.
FaIlure to Follow these InstructIons and warnIngs could result In FIre, explosIon,
burn hazard or carbon monoxIde poIsonIng whIch could cause property damage,
personal Injury or death.
leaK test
Before lighting the appliance, a thorough leak test must be satisfactorily completed using
a non-ammonia soapy water solution (50% non-ammonia soap and 50% water). This is to be
applied with a small brush to all gas joints after connecting the cylinder to the regulator. If
bubbles are seen, indicating a leak, turn off the cylinder and tighten the leaking connection until
a further leak test shows no leaks.
If tightening the connection does not stop the leak, call Metal Fusion, Inc. (800) 783-3885,
for assistance.
neVer use hose/regulator assembly IF leaKIng.